Agri-Fab 45-0491 Betriebsanleitung PDF herunterladen (Seite 9)

STEP 7:

REAR MOUNTED BATTERY ONLY

• Mount the wire harness relay box in front of the

solenoid on the right hand side of the gas tank,

attaching it with a plastic tie.

• Attach the long black wire of the wire harness under

the head of the screw that fastens down the right

hand side of the gas tank.

• Attach the red wire (with circuit breaker) to the rear

solenoid terminal where the battery cable is attached.

• Connect the short red, black and green wires to the

three wires of the switch mounting assembly, joining

together like colored wires.

iNSTALLiNG THE WiRE HARNESS

STEP 8:

• Connect the three wires of the switch mounting

assembly to the wires with mating connectors from

the wire harness, joining together like colored wires.

• Route the end of the wire harness with the green and

black wires around behind the tractor's wiring and

then forward along the right side of the tractor.

• Route the other end of the wire harness around to the

left side of the tractor.

• Loosely attach the wire harness to rear of each side

plate installed in step 4, and to the front corners of the

tractor frame using two plastic ties per side.

• Connect the wire harness to the winch motor using

the pre-assembled nut and washers. Place the brown

wire on the top terminal and the black wire on the

bottom terminal. See figure 6.

• Tighten the plastic ties.

NUT

WASHER

BROWN WiRE

WASHER

,WASHER

BLACK WiRE

FIGURE 6 RIGHT SIDE VIEW

INSTALL HANGER BRACKETS AND SHOULDER

BOLTSTO OUTSIDE OF FRAME

STEP 9: (SEE FIGURE 7)

• Remove the bolt, if present, in the hole directly behind

the brake rod on the left side of the tractor frame.

• Attach the L.H. Hanger Bracket (tube facing out) to the

hole using a 5/16" x 3/4" self threading bolt.

• Install a round head shoulder bolt into the hole that is

9-1/2" to the rear of the bolt you just installed. Secure

it with a 3/8" flange nut on the inside of the frame.

BRAKE ROD

5/16" x 3/4" SELF

THREADING BOLT

FIGURE 7

L.H. HANGER

BRACKET

, \

\\ \, \

\ 3/8" FLANGED

Y, NUT

LEFT SIDE VIEW

STEP 10: (SEE FIGURE 8)

• Remove the bracket, if present, from the hole directly

behind the end of the brake rod on the right side of

the tractor frame. Store the bracket and bolt.

• Attach the R.H. Hanger Bracket to the hole using a

5/16" x 3/4" self threading bolt.

• Install a round head shoulder bolt into the hole that is

9-1/2" to the rear of the bolt you just installed. Secure

it with a 3/8" flange nut on the inside of the frame.

5/16" x 3/4" SELF

THREADING BOLT

R.H. HANGER

BRACKET

RIGHT END OF

BRAKE ROD

SHOULDER

BOLT

FIGURE 8

RIGHT SIDE VIEW

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Agri-Fab 45-0491 Betriebsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer Agri-Fab 45-0491